Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 466)

448 Brocade ICX 6650 Layer 3 Routing Configuration Guide
53-1002603-01
Displaying VRRP and VRRP-E information
Displaying detailed information
To display detailed VRRP or VRRP-E information, enter the show ip vrrp command at any level of the
CLI.
VRID The VRID configured on this interface. If multiple VRIDs are configured on the
interface, information for each VRID is listed in a separate row.
CurPri The current VRRP or VRRP-E priority of this Layer 3 switch for the VRID.
P Whether the backup preempt mode is enabled. If the backup preempt mode is
enabled, this field contains a “P”. If the mode is disabled, this field is blank.
State This Layer 3 switch VRRP or VRRP-E state for the VRID. The state can be one of the
following:
•
Init – The VRID is not enabled (activated). If the state remains Init after you
activate the VRID, make sure that the VRID is also configured on the other
routers and that the routers can communicate with each other.
NOTE: If the state is Init and the mode is incomplete, make sure you have specified
the IP address for the VRID.
•
Backup – This Layer 3 switch is a Backup for the VRID.
•
Master – This Layer 3 switch is the Master for the VRID.
Master addr IP address of the router interface that is currently Master for the VRID.
Backup addr IP addresses of router interfaces that are currently Backups for the VRID.
VIP The virtual IP address that is being backed up by the VRID.
TABLE 81 CLI display of VRRP or VRRP-E summary information (Continued)
Field Description
Brocade#show ip vrrp
Total number of VRRP routers defined: 1
Interface ethernet v3
auth-type simple text password
VRID 3
state master
administrative-status enabled
mode owner
priority 255
current priority 255
track-priority 150
hello-interval 1000 msec
ip-address 192.168.3.1
virtual mac address 0000.5e00.0103
advertise backup: disabled
next hello sent in 00:00:00.7
backup router 192.168.3.2 expires in 00:02:41.3
track-port 1/1/14(up)