Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 User Manual
Page 468
450
Brocade ICX 6650 Layer 3 Routing Configuration Guide
53-1002603-01
Displaying VRRP and VRRP-E information
The ve num option specifies a virtual interface. If you use this option, the command displays VRRP
or VRRP-E information only for the specified virtual interface.
The stat option displays statistics. Refer to
shows a description of the output for the show ip vrrp and show ip vrrp-extended
commands.
TABLE 82
CLI display of VRRP or VRRP-E detailed information
Field
Description
Total number of VRRP (or
VRRP-Extended) routers defined
The total number of VRIDs configured on this Layer 3 switch.
NOTE: The total applies only to the protocol the Layer 3 switch is running. For
example, if the Layer 3 switch is running VRRP-E, the total applies only
to VRRP-E routers.
Interface parameters
Interface
The interface on which VRRP, VRRP v3, VRRP-E, or IPv6 VRRP-E is configured.
If VRRP, VRRP v3, VRRP-E, or IPv6 VRRP-E is configured on multiple interfaces,
information for each interface is listed separately.
auth-type
The authentication type enabled on the interface.
VRID parameters
VRID
The VRID configured on this interface. If multiple VRIDs are configured on the
interface, information for each VRID is listed separately.
state
This Layer 3 switch VRRP, VRRP v3, VRRP-E, or IPv6 VRRP-E state for the VRID.
The state can be one of the following:
•
initialize – The VRID is not enabled (activated). If the state remains
“initialize” after you activate the VRID, make sure that the VRID is also
configured on the other routers and that the routers can communicate
with each other.
NOTE: If the state is “initialize” and the mode is incomplete, make sure you
have specified the IP address for the VRID.
•
backup – This Layer 3 switch is a Backup for the VRID.
•
master – This Layer 3 switch is the Master for the VRID.
administrative-status
The administrative status of the VRID. The administrative status can be one of
the following:
•
disabled – The VRID is configured on the interface but VRRP or VRRP-E
has not been activated on the interface.
•
enabled – VRRP, VRRP v3, VRRP-E, or IPv6 VRRP-E has been activated on
the interface.
mode
Indicates whether the Layer 3 switch is the Owner or a Backup for the VRID.
NOTE: If “incomplete” appears after the mode, configuration for this VRID is
incomplete. For example, you might not have configured the virtual IP
address that is being backed up by the VRID.
NOTE: This field applies only to VRRP or VRRP v3. All Layer 3 switches
configured for VRRP-E are Backups.
priority
The device preferability for becoming the Master for the VRID. During
negotiation, the router with the highest priority becomes the Master.
If two or more devices are tied with the highest priority, the Backup interface
with the highest IP address becomes the active router for the VRID.