Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 243)

Brocade ICX 6650 Layer 3 Routing Configuration Guide 225
53-1002603-01
Displaying OSPF information
Brocade#show ip ospf virtual-link
Syntax: show ip ospf virtual-link [num]
The num parameter displays the table beginning at the specified entry number.
Displaying OSPF ABR and ASBR information
To display OSPF ABR and ASBR information, enter the show ip ospf border-routers command at any
CLI level.
Brocade#show ip ospf border-routers
Syntax: show ip ospf border-routers [ip-addr]
The ip-addr parameter displays the ABR and ASBR entries for the specified IP address.
Displaying OSPF trap status
All traps are enabled by default when you enable OSPF. To disable or re-enable an OSPF trap, refer
to
“Modifying OSPF traps generated” on page 208.
To display the state of each OSPF trap, enter the show ip ospf trap command at any CLI level.
Syntax: show ip ospf trap
Brocade#show ip ospf trap
Interface State Change Trap: Enabled
Virtual Interface State Change Trap: Enabled
Neighbor State Change Trap: Enabled
Virtual Neighbor State Change Trap: Enabled
Interface Configuration Error Trap: Enabled
Virtual Interface Configuration Error Trap: Enabled
Interface Authentication Failure Trap: Enabled
Virtual Interface Authentication Failure Trap: Enabled
Interface Receive Bad Packet Trap: Enabled
Virtual Interface Receive Bad Packet Trap: Enabled
Interface Retransmit Packet Trap: Enabled
Virtual Interface Retransmit Packet Trap: Enabled
Originate LSA Trap: Enabled
Originate MaxAge LSA Trap: Enabled
Link State Database Overflow Trap: Enabled
Link State Database Approaching Overflow Trap: Enabled