Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 489)

Brocade ICX 6650 Layer 3 Routing Configuration Guide 471
53-1002603-01
enabling multicast routing on GRE tunnels , 106
GRE packet , 95
multicast routing over GRE tunnels , 97
point-to-point GRE tunnels , 95
IPv6
advertising address summaries , 160
clearing RIPng routes , 163
clearing tunnel statistics , 405
configuring a manual tunnel , 404
displaying ECMP load-sharing information , 409
displaying interface-level settings , 406
displaying tunnel information , 405
ECMP load sharing , 408
static route parameters , 402
IPv6 over IPv4 tunnels , 403
ipv6 rip summary-address , 160
L
Layer 2
enabling or disabling , 139
Layer 2 switch
basic IP parameters and defaults , 17
configuring IP parameters , 88
displaying IP information , 128
interface IP parameters , 19
IP global parameters , 17
Layer 3
modifying and displaying parameter limits , 134
Layer 3 switch
basic IP parameters and defaults , 11
configuring a default network route , 54
configuring to drop IP packets , 49
IP global parameters , 11
IP interface parameters , 15
load balancing, configuring using multiple static routes , 49
log messages for DHCP , 87
M
management IP address
configuring and specifying the default gateway , 88
Maximum Transmision Unit (MTU)
changing , 28
changing on an individual port , 30
path discovery (RFC 1191) support , 30
Maximum Transmission Unit (MTU)
globally changing , 29
MTU
changing the value for a tunnel interface , 104
configuring path discovery , 105
path discovery , 96
multicast protocols
displaying information , 110
N
network routes
configuring default , 54
O
Open Shortest Path First (OSPF)
differences between version 2 and version 3 , 228
overview , 168
point-to-point links , 169
OSPF
assigning a totally stubby area , 180
assigning an area range , 183
assigning areas , 179
assigning interfaces to an area , 184
assigning virtual links , 189
auth-change-wait-time , 185
authentication-key , 185
block flooding of outbound LSAs , 187
changing administrative distance , 207
changing the reference bandwidth , 194
changing the reference bandwidth for the cost , 192
changing the timer for authentication changes , 186
clearing information , 212
clearing information for areas , 213
clearing redistributed routes from the routing table ,
213
clearing topology information , 213
CLI commands , 214
configirng group Link State Advertisement (LSA)
pacing , 208
configuration , 177
configuring a non-broadcast interface , 188
configuring a point-to-point link , 211
configuring default route origination , 205
configuring external route summarization , 204
configuring graceful restart , 211
cost , 185
dead-interval , 185
defining redistribution filters , 194
designated router election in multi-access networks ,
170