Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 User Manual
Page 425

Brocade ICX 6650 Layer 3 Routing
407
53-1002603-01
IPv6 over IPv4 tunnels
The display command above reflects the following configuration.
This display shows the following information.
TABLE 77
Interface level IPv6 tunnel information
Field
Description
Interface Tunnel status
The status of the tunnel interface can be one of the following:
•
up – IPv4 connectivity is established.
•
down – The tunnel mode is not set.
•
administratively down – The tunnel interface was disabled with the
disable command.
Line protocol status
The status of the line protocol can be one of the following:
•
up – IPv6 is enabled through the ipv6 enable or ipv6 address
command.
•
down – The line protocol is not functioning and is down.
Brocade#show ipv6 inter tunnel 1
Interface Tunnel 1 is up, line protocol is up
IPv6 is enabled, link-local address is 2001:db8::3:4:2 [Preferred]
Global unicast address(es):
2001:db8::1 [Preferred], subnet is 2001:db8::/64
2001:db8::1 [Preferred], subnet is 2001:db8::/64
Joined group address(es):
2001:db8::1:ff04:2
2001:db8::5
2001:db8::1:ff00:1
2001:db8::2
2001:db8::1
MTU is 1480 bytes
ICMP redirects are enabled
No Inbound Access List Set
No Outbound Access List Set
OSPF enabled
Brocade#show running-config interface tunnel 1
!
interface tunnel 1
port-name ManualTunnel1
tunnel mode ipv6ip
tunnel source loopback 1
tunnel destination 10.1.1.1
ipv6 address 2001:db8::1/64
ipv6 address 2001:db8::1/64
ipv6 ospf area 0