Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 470)

452 Brocade ICX 6650 Layer 3 Routing Configuration Guide
53-1002603-01
Displaying VRRP and VRRP-E information
Displaying detailed information for an individual VRID
You can display information about the settings configured for a specified VRRP Virtual Router ID
(VRID). To display information about VRID 1, enter the show ip vrrp vrid command.
To display information about the settings configured for a specified IPv6 VRRP VRID, enter the show
ipv6 vrrp vrid command.
next hello sent in time How long until the Backup sends its next Hello message.
NOTE: This field applies only when this Layer 3 switch is the Master and the
Backup is configured to send Hello messages (the advertise backup
option is enabled).
master router ip-addr expires in
time The IP address of the Master and the amount of time until the Master dead
interval expires. If the Backup does not receive a Hello message from the
Master by the time the interval expires, either the IP address listed for the
Master will change to the IP address of the new Master, or this Layer 3 switch
itself will become the Master.
NOTE: This field applies only when this Layer 3 switch is a Backup.
track port The interfaces that the VRID interface is tracking. If the link for a tracked
interface goes down, the VRRP, VRRP v3, VRRP-E, or IPv6 VRRP-E priority of the
VRID interface is changed, causing the devices to renegotiate for Master.
NOTE: This field is displayed only if track interfaces are configured for this
VRID.
TABLE 82 CLI display of VRRP or VRRP-E detailed information (Continued)
Field Description
Brocade#show ip vrrp vrid 2
VRID 2
Interface ethernet v2
state master
administrative-status enabled
version v2
mode non-owner(backup)
priority 100
current priority 100
hello-interval 1000 msec
dead-interval 0 msec
current dead-interval 3600 msec
preempt-mode true
ip-address 10.1.1.5
virtual mac address 0000.0000.0102
advertise backup: disabled
next hello sent in 00:00:01.0