Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 464)

446 Brocade ICX 6650 Layer 3 Routing Configuration Guide
53-1002603-01
Displaying VRRP and VRRP-E information
To change the Master priority back to the default Owner priority 255, enter no followed by the
command you entered to change the priority. For example, to change the priority of a VRRP Owner
back to 255 from 110, enter the following command.
Brocade(config-if-e10000-1/1/6-vrid-1)#no owner priority 110
You cannot set the priority to 255 using the owner priority command.
Displaying VRRP and VRRP-E information
You can display the following information for VRRP or VRRP-E:
• Summary configuration and status information
• Detailed configuration and status information
• VRRP and VRRP-E statistics
• CPU utilization statistics
Displaying summary information
To display summary information for a Layer 3 switch for VRRP, enter the show ip vrrp brief
command at any level of the CLI.
To display summary information for IPv6 VRRP, enter the show ipv6 vrrp brief command at any level
of the CLI.
Brocade#show ip vrrp brief
Total number of VRRP routers defined: 1
Interface VRID CurPri P State Master addr Backup addr VIP
1/1/6 1 255 P Init 192.163.5.1 192.168.5.3 192.168.5.1
Brocade#show ipv6 vrrp brief
Total number of VRRP routers defined: 1
Interface VRID CurPri P State Master addr
Backup addr
VIP
1/1/5 1 255 P Master Master addr: Local
Backup addr: 2001:db8:212:f2ff:fea8:3900
VIP : 2001:db8::1