Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 - Manual (Page 19)

Brocade ICX 6650 Layer 3 Routing Configuration Guide 1
53-1002603-01
Chapter
1
IP Configuration
Table 1 lists the IP features Brocade ICX 6650 devices support. These features are supported with
the full Layer 3 software image, except where explicitly noted.
TABLE 1 Supported IP features
Feature Brocade ICX 6650
BootP/DHCP relay Yes
Specifying which IP address will be
included in a DHCP/BootP reply packet Yes
DHCP Server Yes
DHCP Client-Based Auto-Configuration Yes
DHCP Client-Based Flash image
Auto-update Yes
DHCP assist Yes
Equal Cost Multi Path (ECMP) load sharing Yes
IP helper Yes
Single source address for the following
packet types:
•
Telnet
•
TFTP
•
Syslog
•
SNTP
•
TACACS/TACACS+
•
RADIUS
•
SSH
•
SNMP
Yes
IPv4 point-to-point GRE IP tunnels Yes
Routes in hardware maximum:
Up to 7168 routes Yes
Routing for directly connected IP subnets Yes
Virtual Interfaces:
Up to 512 virtual interfaces Yes
31-bit subnet mask on point-to-point
networks Yes
Address Resolution Protocol (ARP) Yes
Reverse Address Resolution Protocol
(RARP) Yes
IP follow Yes
Proxy ARP Yes