Displaying ip information – layer 2 switches, Displaying ip information – layer 2, Switches – Brocade Communications Systems Layer 3 Routing Configuration ICX 6650 User Manual
Page 146: Displaying global ip configuration information
128
Brocade ICX 6650 Layer 3 Routing Configuration Guide
53-1002603-01
Displaying IP configuration information and statistics
Displaying IP information – Layer 2 Switches
You can display the following IP configuration information statistics on Layer 2 Switches:
•
Global IP settings – refer to
“Displaying global IP configuration information”
•
ARP entries – refer to
•
IP traffic statistics – refer to
“Displaying IP traffic statistics”
Displaying global IP configuration information
To display the Layer 2 Switch IP address and default gateway, enter the show ip command.
Syntax: show ip
This display shows the following information.
resp from
loopback
The number of RIP responses received from loopback interfaces.
packets
rejected
This information is used by Brocade customer support.
TABLE 23
CLI display of global IP configuration information – Layer 2 Switch
Field
Description
IP configuration
Switch IP address
The management IP address configured on the Layer 2 Switch. Specify this
address for Telnet .
Subnet mask
The subnet mask for the management IP address.
Default router address
The address of the default gateway, if you specified one.
Most recent TFTP access
TFTP server address
The IP address of the most-recently contacted TFTP server, if the switch has
contacted a TFTP server since the last time the software was reloaded or the
switch was rebooted.
Configuration filename
The name under which the Layer 2 Switch startup-config file was uploaded or
downloaded during the most recent TFTP access.
Image filename
The name of the Layer 2 Switch flash image (system software file) that was
uploaded or downloaded during the most recent TFTP access.
TABLE 22
CLI display of IP traffic statistics – Layer 3 Switch (Continued)
Field
Description
Brocade# show ip
Switch IP address: 192.168.1.2
Subnet mask: 255.255.255.0
Default router address: 192.168.1.1
TFTP server address: None
Configuration filename: None
Image filename: None