Festo Контроллеры двигателя SFC-LAC - Manual (Page 103)

5. Commissioning
5−21
Festo GDCP−SFC−LACI−IO−EN en 0812NH
5.3.1 Installing the FCT
Note
FCT PlugIn SFC−LAC V 3.0.0 supports the motor controller
SFC−LACI−...−IO with firmware version V 1.00.
Check with later versions of the SFC−LACI whether an upĆ
dated PlugIn is provided. If necessary, consult Festo.
Note
Administrator rights are required for installing the FCT.
The FCT is installed on your PC with an installation program.
1. Close all programs.
2. Place the Festo Configuration Tool" CD in your CD ROM
drive. If Auto−Run is activated on your system, the inĆ
stallation starts automatically and you can skip steps 3
and 4.
3. Select [Execute] in the Start menu.
4. Enter D:\setup (if necessary replace D with the letter of
your CD ROM drive).
5. Follow the instructions on the screen.