beautypg.com

2 rerun non-complete targets button, 3 parameters button, 3 operation details log – HP Insight Control Software for Linux User Manual

Page 129

background image

All task level results

All parameters displayed in the Parameters pop-up window

Target level results, including:
— All information displayed in the target status table
— All target details, including all information displayed in the operation status table and

the log for each operation

NOTE:

If you select All Systems for the report, the target level results are displayed

for all targets, each separated by a line.

11.4.2.2 Rerun non-complete targets button

The Rerun Non-Complete Targets button is enabled only when the following conditions exist:

At least one target for the task has a Failed or Cancelled status.

All targets for the task are in a Terminal state. That is, no targets for the task are in the
Pending

, Running, or Cancelling state.

If an Insight Control for Linux tool does not support a task to be rerun, the Rerun Non-Complete
Targets

button is not available.

When you select the Rerun Non-Complete Targets button, the Verify Target Systems screen
is displayed, and the targets that had a Failed or Cancelled status from the original task are
preselected. You have the option to add more targets or remove some of the preselected targets.
When you navigate through the task, the values selected in the original task are automatically
reselected. Again, you have the option to modify or retain these values.

11.4.2.3 Parameters button

The Parameters button opens a new window that provides the following information:

A summary of the task level information

The values that were run as part of the task, which are known as the Parameters

These values apply to the task as a whole and are the same for all targets on which the task
was run.

Figure 11-4

provides an example of the task parameters that were used during a RHEL OS

installation.

Figure 11-4 Task parameters window

11.4.3 Operation details log

As illustrated in

Figure 11-5

, the Operation Details Log contains the results from executing the

selected operation on the selected target.

11.4 Common task results

129