HP StorageWorks 3000 RAID Array - Manual (Page 93)

Using Command Console 3-47
Compaq Confidential – Need to Know Required
Writer: Bob Young Project: Command Console V2.2 for the RAID Array 3000 (Pedestal and Rack Mount Models) User’s Guide Comments:
Part Number: AA-RBF2C-TE File Name: d-ch3 Using Command Console.doc Last Saved On: 12/5/00 10:20 AM
Tips and Notes for Setting Up Pagers
■ If you need to dial a code to access an outside number, it must proceed
the phone number in the pager number field.
■ Do not use commas with alphanumeric pagers, except if required to
access an outside line.
■ If you are configuring an alphanumeric pager, you must supply the
paging service provider’s TAP service modem number in the Pager
Number Text box.
■ When you enter a numeric pager number, you can optionally use one or
more commas to specify a two-second wait interval. Each comma
causes the pager dialer to wait two seconds before sending the pager
identification number to the paging company. You may need to add
additional commas using the trial and error method so that Command
Console will pause long enough for the pager company greetings to
complete.
■ Not every paging company requires a pager identification number. If
your pager is assigned a unique phone number to call the paging
company, do not enter a pager identification number.
■ Command Console supports the TAP paging protocol.
■ See your pager documentation to determine which special characters are
supported.
■ Consult Command Console’s HELP for the latest information on how to
diagnose problems that could arise when sending pages. Help provides
instructions on how to put AES into debug mode.