HP StorageWorks 3000 RAID Array - Manual (Page 66)

3-20 Command Console V2.2 for the RAID Array 3000 (Pedestal and Rack Mount Models) User’s Guide
Compaq Confidential – Need to Know Required
Writer: Bob Young Project: Command Console V2.2 for the RAID Array 3000 (Pedestal and Rack Mount Models) User’s Guide Comments:
Part Number: AA-RBF2C-TE File Name: d-ch3 Using Command Console.doc Last Saved On: 12/5/00 10:20 AM
Opening a Storage Window
1. Connect to a storage subsystem.
2. In the Navigation window, double click a system folder.
3. Double-click the Storage window icon to open a Storage window.
Configuring a Single Controller
Your controller’s operating parameters are stored in property sheets. Double-
clicking a controller icon in the Storage window or right clicking on the icon
and selecting Properties accesses controller property sheets. To access a
property sheet, click its tab.
Changes to controller settings require a controller restart to place the changes
in effect. The program prompts you for confirmation before it restarts your
controller.
After you change a parameter that causes a controller restart, there is
approximately a 90-second delay while the controller reinitializes. If the
controller does not communicate with client after this delay, power cycle the
RA3000.
1. Access the controller’s property sheets by double-clicking the
controller’s icon. The controller property sheet will be displayed. The
controller has four property sheets and can be accessed by clicking on a
tab.