HP StorageWorks 3000 RAID Array - Manual (Page 55)

Using Command Console 3-9
Compaq Confidential – Need to Know Required
Writer: Bob Young Project: Command Console V2.2 for the RAID Array 3000 (Pedestal and Rack Mount Models) User’s Guide Comments:
Part Number: AA-RBF2C-TE File Name: d-ch3 Using Command Console.doc Last Saved On: 12/5/00 10:20 AM
Establishing a SCSI Connection, Single Controller
If client’s host operating system is Windows NT or Windows 2000, you can
connect to, monitor and manage one storage subsystem over the SCSI bus.
Before you can connect to your storage subsystem over the SCSI bus, at least
one virtual disk must be configured for the controller. To create the first virtual
disk you must use a serial connection to the subsystem. The procedure to
create the first virtual disk is summarized as follows:
■ Establish a serial connection to your RAID using the Establishing a
Serial Connection, Single Controller procedure provided in this User’s
Guide.
■ Create a virtual disk. See “ Creating a Virtual Disk” .
■ Reboot your system.
■ Start the disk administrator, create the partition and assign the drive
letter for the two virtual disks.
To connect over the SCSI bus proceed, as follows:
1. Open the HSZ22 Storage window (Start|Programs|Command
Console|HSZ22 Storage window).
2. When the Connection Dialog box displays, select the SCSI option.
3. When the HSZ Management: Local SCSI Connection dialog box
appears, select a drive, then click OK (Figure 3– 7). Command Console
will shortly connect to the RA3000 and display the Storage window.
Figure 3-7. HSZ22 Management: Local SCSI connection dialog box