HP StorageWorks 3000 RAID Array - Manual (Page 44)

2-18 Command Console V2.2 for the RAID Array 3000 (Pedestal and Rack Mount Models) User’s Guide
Compaq Confidential – Need to Know Required
Writer: Bob Young Project: Command Console V2.2 for the RAID Array 3000 (Pedestal and Rack Mount Models) User’s Guide Comments:
Part Number: AA-RBF2C-TE File Name: c-ch2 Installing and Setting Up the Command Client.doc Last Saved On: 12/5/00 10:31 AM
Installing the Agent Software
If you use command console over a TCP/IP network, then you will need to
install the Agent software on the computer that is connected to your RA3000.
The Agent software provides communication over the network between your
client system and the RA3000. Refer to the Getting Started RAID Array 3000
Installation Guide for your operating system and platform.
Adding a System to the Navigation Tree
When you add a system to the Navigation Tree, you are telling the Client
software to monitor that system. Before you add a system to the Navigation
Tree, you need to have the agent software already installed on that system and
the name of your client system on the agent’s list of client system entries.
1. From the File menu, click Add System.
2. Enter your host’s name or your host’s IP address in the host name or
TCP/IP address text box (Figure 2– 14), and click Apply. After you click
Apply, client adds an icon for the added system in the Navigation
Window (Figure 2– 15). In the host name or TCP/IP address text box,
you are told the TCP/IP address has been resolved for the name you
entered.