HP StorageWorks 3000 RAID Array - Manual (Page 23)

Introduction 1-7
Compaq Confidential – Need to Know Required
Writer: Bob Young Project: Command Console V2.2 for the RAID Array 3000 (Pedestal and Rack Mount Models) User’s Guide Comments:
Part Number: AA-RBF2C-TE File Name: b-ch1 Introduction.doc Last Saved On: 12/4/00 12:10 PM
Table 1-4
How to Set Up SWCC for a Local SCSI Bus Connection
Step Procedure
1 Install the Client software. See Chapter 2 “ Installing and Setting Up the
Command Console Client ”
2 Create a virtual disk by using a serial connection. See Chapter 2 “ Installing and
Setting Up the Command Console Client ” .
3 Set up a SCSI connection for the hardware. See Figure 1-3.
4 Use SWCC to establish a SCSI bus connection (Start|Programs|Command
Console|HSZ22 Storage Window). For more information, see “ Establishing a
SCSI Connection, Single Controller” and Establishing a SCSI Connection, Dual
Controller” in Chapter 3.
Host
SCSI host bus
Storage
subsystem
Client
LKG-10477-W
Server
Figure 1-3. Local SCSI bus connection