HP StorageWorks 3000 RAID Array - Manual (Page 17)

Compaq Confidential – Need to Know Required
Writer: Bob Young Project: Command Console V2.2 for the RAID Array 3000 (Pedestal and Rack Mount Models) User’s Guide Comments:
Part Number: AA-RBF2C-TE File Name: b-ch1 Introduction.doc Last Saved On: 12/4/00 12:10 PM
Chapter
1
Introduction
This chapter defines StorageWorks Command Console, describes Command
Console’s features, and provides network and device support information.
What is StorageWorks Command
Console?
SWCC is a program, which provides a method of monitoring, configuring, and
troubleshooting your RA3000. Command Console is comprised of three
components: The Command Console Client, the HSZ22 Client, and the HSZ22
Agent.
You can use Command Console with three different connections
(Table 1-1): Serial, Small Computer System Interface (SCSI), and TCP/IP
network. You need to install the Client software with all of these connections.
If you plan to use Command Console over a TCP/IP network, you need to also
install the agent software.
Table 1-1
Connections That Can Be Used with SWCC
Connections That Can Be Used with SWCC Agent Software Required?
Network connection by means of TCP/IP Yes
Direct serial connection No
Host-bus SCSI connection No