HP StorageWorks 3000 RAID Array - Manual (Page 90)

3-44 Command Console V2.2 for the RAID Array 3000 (Pedestal and Rack Mount Models) User’s Guide
Compaq Confidential – Need to Know Required
Writer: Bob Young Project: Command Console V2.2 for the RAID Array 3000 (Pedestal and Rack Mount Models) User’s Guide Comments:
Part Number: AA-RBF2C-TE File Name: d-ch3 Using Command Console.doc Last Saved On: 12/5/00 10:20 AM
Setting Up Pager Notification
Command Console will monitor events on your storage subsystem and notify
you of critical events by pager. You can use either an alphanumeric or numeric
pager. If you use an alphanumeric pager text messages will be sent to you. The
message will include the host system name, storage subsystem name, and a
text event message. For numeric pagers you must assign numbers to your host
systems and storage subsystems. The event message will also be a four-
number code, indicating a critical event.
Command Console can send messages that notify either you or a group of
people you designate at different shift times.
The steps for setting up critical event notification by pager are:
■ Set pager preferences. This includes setting your modem’s COM port,
pager service baud rate, and polling interval.
■ Define a user profile. This includes entering your pager number,
identification number (alphanumeric pagers only), and the time period
in which you want to be notified.
■ For numeric pagers only, assign pager codes. This includes assigning
three-digit numbers to the host systems and storage subsystems you
want to monitor.
■ As an option, create a group of people to notify from the user profiles
you have defined.
CAUTION: To receive pages, the following must occur:
■ The Asynchronous Event Service (AES) must be running.
■ The agent service must be running.
■ In the agent’s list of client system entries, you must select the TCP/IP
notification scheme for your client system.