HP StorageWorks 3000 RAID Array - Manual (Page 122)

5-2 Command Console V2.2 for the RAID Array 3000 (Pedestal and Rack Mount Models)
Backing up Data Files
You should consistently back up your data files to ensure their integrity. Make
sure you have a consistent and comprehensive subsystem backup policy in
place while using command console. If you do not maintain consistent
backups of your data, you put it at risk.
Following good subsystem management practice, you should back up the data
on your disk drives to aid in recovery if there is a primary system failure, if the
integrity of a storage device becomes questionable, or if you experience gross
user error.
The client software does not automatically back up your data for you. Use the
appropriate host backup utilities for this purpose.
Updating Controller Firmware
See the release notes for your version of client for information and restrictions
on downloading various versions of controller software. You can upgrade your
firmware using a network or a SCSI connection as follows:
NOTE: If the operating system is installed on the RA3000, you cannot use SWCC to
download firmware. Refer to the Getting Started RAID Array 3000 Installation Guide for
your operating system and platform.
1. From the Storage menu, select Controller, then Update Firmware
(Figure 5– 1).
Figure 5-1. Update firmware command