HP StorageWorks 3000 RAID Array - Manual (Page 27)

Compaq Confidential – Need to Know Required
Writer: Bob Young Project: Command Console V2.2 for the RAID Array 3000 (Pedestal and Rack Mount Models) User’s Guide Comments:
Part Number: AA-RBF2C-TE File Name: c-ch2 Installing and Setting Up the Command Client.doc Last Saved On: 12/5/00 10:31 AM
Chapter
2
Installing and Setting Up the Command
Console Client
This chapter covers how to install the Command Console Client and set up the
software so that it can communicate with your RA3000.
Before you can use StorageWorks Command Console (SWCC), you will need
to complete the following steps:
1. Install the Command Console Client. The HSZ22 Client will also install.
The HSZ22 Storage window displays the status of the virtual disks
connected to a particular controller.
2. Create a virtual disk by using a serial connection.
3. If you are planning to use SWCC over a TCP/IP network, you also need
to install the Agent software on the computer that is connected to your
HSZ22 controller. Refer to the Getting Started RAID Array Installation
Guide for your operating system and platform.