HP MPX200 Multifunction Router - Manual (Page 170)

•
HP recommends that the boot LUN is presented as ID 0. Presenting it with another ID can
cause the boot LUN to not be discovered when a device scan is performed.
•
Once the vPar is booted, check all the boot paths and the boot options in the vPar data base,
and modify them to reflect the new boot paths.
Example boot processes in vPar environments
PA-RISC systems
Once the boot disk is found by the recommended search procedure for PA-RISC systems, the vPar
needs to be booting with –o “” to ensure the first vPar boots with no options.
Example of winona1 vpar boot
BCH> bo
nl
interact with IPL? y
nl
.
nl
ISL> hpux /stand/vpmon vparload winona1 –o “”
nl
Itanium Systems
Once the boot disk is found by the recommended search procedure for Itanium systems, the vPar
needs to be booting with –o “” to ensure the first vPar boots with no options. Itanium systems
require vPar mode for booting vPar. Follow the recommended procedure for setting vPar mode.
Example of winona1 vpar boot
EFI_Shell> fs0:
nl
Fs0:\> vparconfig reboot vPars
nl
nl
System reboots and needs to go to EFI again, interrupt this manually:
nl
nl
Fs0:\> hpux boot vpmon
nl
nl
Once in the monitor:
nl
MON> vparload –p winona1 -o “”
170 HP-UX Boot volume migration