HP MPX200 Multifunction Router - Manual (Page 140)

as hh:mm:ss and is an estimate based on the current I/O performance in 30 second intervals. Job
ETC is displayed with job details either through CLI or the GUI.
CLI Example:
.
.
.
Migration Status Running
I/O Size 64 KB
Migration State 42% Complete
Migration Performance 17 MBps
Migration Curr Performance 25 MBps
Job ETC 0 hrs 1 min 54 sec
.
.
.
GUI Example:
Operational Behavior
The ETC is calculated every 30 seconds by dividing the total blocks outstanding (to be copied,
flushed, compared or scrubbed) by the job’s current performance (MBps).
NOTE: Because the performance of a job depends on numerous external factors, ETC values
may dynamically change during the job’s execution.
Offline ETC job
•
If an offline job is Running, ETC is the total outstanding blocks that are yet be copied from
source to destination, divided by the job’s current performance (MBps):
Outstanding blocks / current performance MBps = ETC
•
If an offline job is running with the Verify option, ETC is the total remaining blocks that are
yet to be copied plus the size or the source LUN, divided by the job’s current performance
(MBps):
Outstanding blocks + source LUN size / current performance MBps = ETC
•
If an offline job is in Verify state, ETC is the total outstanding blocks that are yet to be verified
from source to destination, divided by the job’s current performance (MBps):
Outstanding blocks / current performance MBps = ETC
•
If an offline scrubbing job is running, ETC is the number of passes left times the size of the
source LUN plus the number of blocks left for the current pass, divided by the job’s current
performance (MBps):
(Number of passes left x size of source LUN) + number of blocks left for the current pass /
current performance MBps = ETC
140 Performance and best practices