HP MPX200 Multifunction Router - Manual (Page 112)

System Log Level (Default,Min=0, Max=2) [0 ]
Time To Target Device Offline (Secs,Min=0, Max=120)[0 ]
nl
All attribute values that have been changed will now be saved.
set vpgroups
Enables or disables the VP groups, and specifies a name to each VP group. Although VpGroup 1
cannot be disabled, you can change its name.
Authority
admin
Syntax
set vpgroups
Examples
The following shows an example of the set vpgroups command.
MPX200 <1> (admin) #> set vpgroups
The following wizard will query for attributes before persisting
and activating the updated mapping in the system configuration.
If you wish to terminate this wizard before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring VpGroup: 1
-------------------------
VpGroup Name (Max = 64 characters) [VPGROUP_1 ] VPGroup 1
All attribute values for VpGroup 1 that have been changed will now be saved.
Configuring VpGroup: 2
-------------------------
Status (0=Enable, 1=Disable) [Enabled ]
VpGroup Name (Max = 64 characters) [VPGROUP_2 ] VPGroup 2
All attribute values for VpGroup 2 that have been changed will now be saved.
Configuring VpGroup: 3
-------------------------
Status (0=Enable, 1=Disable) [Enabled ]
VpGroup Name (Max = 64 characters) [VPGROUP_3 ] VPGroup 3
All attribute values for VpGroup 3 that have been changed will now be saved.
Configuring VpGroup: 4
-------------------------
Status (0=Enable, 1=Disable) [Enabled ]
VpGroup Name (Max = 64 characters) [VPGROUP_4 ] VPGroup 4
nl
All attribute values for VpGroup 4 that have been changed will now be saved.
show array
Displays the status of array objects identified by the DMS.
Authority
guest
Syntax
show array
Examples
The following example illustrates the show array command:
nl
MPX200 <1> #> show array
nl
nl
Array Information
-----------------
Symbolic Name HP MSA2012fc-0
112 Command line interface