HP MPX200 Multifunction Router - Manual (Page 102)

rescan devices
Rescan the devices for new LUNs.
Authority
admin
Syntax
rescan devices
Examples
The following shows an example of the rescan devices command.
nl
MPX200 <1> (admin) #> rescan devices
nl
Index State (Symbolic Name, WWPN/WWNN,WWPN/iSCSI Name, Ip Address)
----- ----- ------------------------------------------------------
0 Online HP HSV200-0, 50:00:1f:e1:50:0a:e1:49
1 Online DGC RAID-2, 50:06:01:62:41:e0:49:2e
2 Online HP HSV210-2, 50:00:1f:e1:50:0a:37:18
3 Online NETAPP LUN-3, 50:0a:09:82:98:8c:a7:79
nl
Please select a Array/Target from the list above ('q' to quit): 0
nl
Successfully initiated rediscovery on selected targets.
reset
Restores the router configuration parameters to the factory default values.
The reset factory command deletes all LUN mappings, as well as all persistent data regarding
targets, LUNs, initiators, virtual port group settings, log files, iSCSI and MGMT (management port)
IP addresses, FC and Ethernet port statistics, and passwords. This command also restores the factory
default IP addresses. Issue the reset factory command on either an individual blade or on the
chassis. On the chassis, this command resets both the blades to their factory defaults.
The reset mappings command clears all information except the MGMT and iSCSI IP address.
Authority
admin
Syntax
reset
Keywords
Deletes router configuration and reverts the settings to the factory defaults. factory
Deletes router mappings and resets them to factory defaults. mappings
Examples
The following example shows the reset factory command:
MPX200 <1> (admin) #> reset factory
Are you sure you want to restore to factory default settings (y/n): y
Please reboot the System for the settings to take affect.
The following example shows the reset factory command on the chassis:
MPX200 <1> (admin) #> reset factory
This command will reset BOTH blades to there factory defaultsettings. Both blades will be rebooted automatically.
Are you sure you want to reset the chassis to factory defaults? (y/n): y
The following example shows the reset mappings command:
102 Command line interface