Remotepeer, Authority, Syntax – HP MPX200 Multifunction Router User Manual
Page 101: Keywords, Examples
Priorities have been successfully re-adjusted.
remotepeer
Identifies the remote router used at a remote site. The remote router establishes Native IP connectivity
to perform remote data migration operations. Use this command to add and remove remote peers.
Authority
miguser
Syntax
remotepeer
Keywords
Adds a remote router at a remote site.
add
Replaces the remote router’s management and iSCSI port information with its own information.
rm
Examples
The following shows an example of the remotepeer add command.
nl
MPX200 <1> (admin) (miguser)#> remotepeer add
nl
A list of attributes with formatting and current values will follow.
nl
Enter a new value or simply press the ENTER key to accept the current value.
nl
If you wish to terminate this process before reaching the end of the list
nl
press 'q' or 'Q' and the ENTER key to do so.
nl
PEER MGMT port address (IPv4 or IPv6) [0.0.0.0] 172.35.14.85
nl
Contacting PEER system (timeout=120 seconds) ...
nl
Remote System Information
------------------------------------------------------
Product Name DTA2800
Symbolic Name Blade-1
Serial Number 0906E00039
No.of iSCSI Ports 2
nl
iSCSI Base Name iqn.1992-08.com.netapp:dta.0834e00029.b1
nl
Mgmt IPv4 Address 172.35.14.85
iSCSI Port 1 IPv4 Address 40.40.40.40
iSCSI Port 1 IPv6 Link-Local fe80::2c0:ddff:fe13:1734
iSCSI Port 2 IPv6 Link-Local fe80::2c0:ddff:fe13:1735
nl
Please select an ISCSI IP Address from REMOTE system above(IPv4 or IPv6)
[0.0.0.0 ] 40.40.40.40
iSCSI Port 1 IPv4 Address 40.40.40.61
iSCSI Port 1 IPv6 Link-Local fe80::2c0:ddff:fe1e:f80a
iSCSI Port 2 IPv6 Link-Local fe80::2c0:ddff:fe1e:f80b
nl
Please select an ISCSI IP Address from LOCAL system above(IPv4 or IPv6)
[0.0.0.0 ] 40.40.40.61
Do you wish to add another ISCSI connection to the REMOTE system (y/n): n
Connect to Remote System Blade-1(0906E00039) using connection(s):
0) 40.40.40.61(LOCAL) to 40.40.40.40(REMOTE)
Remote Peer usage [1=Data Migration, 2=RemoteMaps] [Data Migration]
Do you wish to add the REMOTE system above (y/n): y
RemoteAdd: Remote Call set the peer usage type to 1
All attribute values that have been changed will now be saved.
The following example shows the remotepeer rm command:
MPX200 <1> (admin) #> remotepeer rm
Index (Symbolic Name/Serial Number)
------------------------------------------------------
0 Blade-1(0906E00095)
Please select a remote system from the list above ('q' to quit): 0
All attribute values that have been changed will now be saved.
Commands
101