Configuring the switch, To display the current radius configuration – HP Brocade 4Gb SAN Switch for HP BladeSystem p-Class User Manual
Page 51
Fabric OS 5.0.0 procedures user guide
51
8.
Open the
user
file in a text editor and add user names and roles for users who will be accessing the
switch. For example, to set up an account called
JohnDoe
with the admin role:
The
user
file is located in the RADIUS configuration directory.
9.
Save the
user
file.
10.
Enter this command to start the RADIUS server:
/usr/local/sbin/radiusd
11.
Log in to a client switch and use the
aaaconfig
command to configure it as a client and enable
RADIUS service, as described in ”
To add a RADIUS server to the switch configuration:
and ”
To enable or disable RADIUS service:
12.
Log out.
When you log in to the switch again, RADIUS service is in force.
Configuring the switch
The following procedures show how to use the aaaconfig command to set up a switch for RADIUS service.
To display the current RADIUS configuration
1.
Connect to the switch and log in as admin.
2.
Enter this command:
If a configuration exists, its parameters are displayed. If RADIUS service is not configured, only the
parameter heading line is displayed. Parameters include:
JohnDoe Auth-Type := Local, User-Password == “johnPassword”
HP-Auth-Role = “admin”
switch:admin> aaaConfig --show
Position
The order in which servers are contacted to provide service
Server
The server names or IP addresses
Port
The server ports
Secret
The shared secrets
Timeouts
The length of time servers have to respond before the next server is contacted
Authentication The type of authentication being used on servers