HP Brocade 4Gb SAN Switch for HP BladeSystem p-Class - Manual (Page 159)

Fabric OS 5.0.0 procedures user guide 159
In this example, the list is empty:
To add a member to the ACL:
1. Connect to the switch and log in as admin.
2. Issue the
msconfigure
command.
The command becomes interactive.
3. At the select prompt, enter
2
to add a member based on its port/node WWN.
4. Enter the WWN of the host to be added to the ACL.
5. At the prompt, enter
1
to verify the WWN you entered was added to the ACL.
6. After verifying that the WWN was added correctly, enter
0
at the prompt to end the session.
7. At the
Update the FLASH?
prompt, enter
y
.
8. Press Enter to update the nonvolatile memory and end the session.
switch:admin> msconfigure
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [1] 1
MS Access list is empty.
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
done ...
switch:admin>