HP Brocade 4Gb SAN Switch for HP BladeSystem p-Class - Manual (Page 36)

36 Performing basic configuration tasks
A message appears, verifying that the Track Changes feature is on:
The output from the Track Changes feature is dumped to the system message log for the switch. Use the
errdump
or
errshow
command to view the log.
Items in the system message log created from the Track Changes feature are labeled
TRCK
; for example:
2004/08/24-08:45:43, [TRCK-1001], 212,, INFO, ras007, Successful login by user
admin.
To display the status of the Track Changes feature:
1. Connect to the switch and log in as admin.
2. Issue the
trackchangesshow
command.
The status of the Track Changes feature is displayed as either
on
or
off
. The display specifies
whether the Track Changes feature is configured to send SNMP traps:
To view the switch status policy threshold values:
1. Connect to the switch and log in as admin.
2. Issue the
switchstatuspolicyshow
command at the command line.
Whenever there is a switch change, an error message is logged and an SNMP
connUnitStatusChange
trap is sent.
For the SAN Switch 2/8V, SAN Switch 2/16V, SAN Switch 2/32, and SAN Switch 4/32, the output is
similar to the following:
switch:admin> trackchangesset 1
Committing configuration...done.
switch:admin>
switch:admin> trackchangesshow
Track Changes status: ON
Track Changes generate SNMP-TRAP: NO
switch:admin>
switch:admin> switchstatuspolicyshow
The current overall switch status policy parameters:
Down Marginal
----------------------------------
PowerSupplies 2 1
Temperatures 2 1
Fans 2 1
Flash 0 1
MarginalPorts 5 2
FaultyPorts 2 1
MissingSFPs 2 1
switch:admin>