HP Brocade 4Gb SAN Switch for HP BladeSystem p-Class - Manual (Page 144)

144 Administering advanced performance monitoring
NOTE: The command examples use the
slot/port
syntax required by the Core Switch 2/64 and the
SAN Director 2/128. For HP StorageWorks SAN Switch 2/8V, SAN Switch 2/16V, SAN Switch 2/32,
and SAN Switch 4/32, use only the port number where needed in the commands.
Table 23 Advanced performance monitoring commands
Command Description
perfaddeemonitor Add an end-to-end (EE) monitor to a port.
perfaddipmonitor Add an IP monitor to a port.
perfaddreadmonitor Add a SCSI Read monitor to a port.
perfaddrwmonitor Add a SCSI Read and Write monitor to a port.
perfaddscsimonitor Add a SCSI traffic frame monitor to a port.
perfaddusermonitor Add a user-defined monitor to a port.
perfaddwritemonitor Add a SCSI Write monitor to a port.
perfcfgclear Clear the performance monitoring settings from
nonvolatile memory.
perfcfgrestore Restore performance monitoring settings from
nonvolatile memory.
perfcfgsave Save the current performance monitoring settings
to nonvolatile memory.
perfclralpacrc Clear an AL_PA device CRC count by the port and
AL_PA.
perfdeleemonitor Delete an end-to-end monitor on port.
perfdelfiltermonitor Delete a filter-based monitor.
perfmonitorclear Clear statistics counters of end-to-end, filter-based,
and ISL monitors on a port.
perfmonitorshow Display end-to-end, filter-based, and ISL monitors
on a port.
perfsetporteemask Set overall mask for end-to-end monitors.
perfshowalpacrc Display the AL_PA CRC count by port or by
AL_PA.
perfshowporteemask Display the current end-to-end mask of a port.