HP Officejet Pro X576 Multifunction Printer series - Manual (Page 51)

xxxx::xxxx:xxxx:xxxx:xxxx
2. To open the HP Embedded Web Server, type the IP address (IPv4) into the address line of a Web
browser. For IPv6, use the protocol established by the Web browser for entering IPv6 addresses.
3. Click the Networking tab to obtain network information. You can change settings as needed.
Set or change the product password
Use the HP Embedded Web Server to set a password or change an existing password for a product on
a network so unauthorized users cannot change the product settings.
1. Type the product IP address into the address line of a Web browser. Click the Settings tab, click
Security, and then click the Password Settings link.
NOTE: If a password has previously been set, you are prompted to type the password. Type
“admin” for User Name along with the password, and then click the Apply button.
2. Type the new password in the Password box and in the Confirm Password box.
3. At the bottom of the window, click the Apply button to save the password.
Manually configure IPv4 TCP/IP parameters from the control panel
Use the control-panel menus to manually set an IPv4 address, subnet mask, and default gateway.
1. Touch the Setup button.
2. Scroll to and touch the Network Setup menu.
3. Touch the Advanced Setup menu, and then touch the IPv4 Settings button.
4. Touch the Manual IP Address button
5. Use the numeric keypad to enter the IP address, and touch the OK button. Touch the Yes button to
confirm.
6. Use the numeric keypad to enter the subnet mask, and touch the OK button. Touch the Yes button
to confirm.
7. Use the numeric keypad to enter the default gateway, and touch the OK button. Touch the Yes
button to confirm.
ENWW Connect the product to a network 35