HP NonStop G-Series - Manual (Page 326)

Recovery Procedure D
EDIT VS Error Recovery Procedures
E–10 058061 Tandem Computers Incorporated
4. Because the error message did not name the recovery file, you must
type the FILES or FUP INFO * command at the command interpreter to
find the name of the recovery file. For example:
4 FILES
AESOP PEEP SHAKE ZZVS972
5
5. Follow Steps 5, 6, 7, 8, 13, 14, and 15 of Procedure A.
Recovery Procedure D If the herringbone pattern appears on your screen, press RESET three times
to put the terminal into self-test mode. Then go to Procedure E.
Recovery Procedure E Use this procedure if:
You press a numbered function key and nothing happens.
You press RESET three times and put the 6520 or 6530 into self-test
mode.
Recovering from these problems is not difficult. However, if you are not
careful, you will end up with 24 blank lines in your file instead of the 24
lines that were on your screen when the error occurred.
1. Press RESET twice to unlock the keyboard.
2. If you receive an I/O error message, such as this:
VS ABORTED BECAUSE OF I/O ERROR - $TERM1
go to Procedure A; otherwise, go to Step 3.