HP NonStop G-Series - Manual (Page 324)

Recovery Procedure B
EDIT VS Error Recovery Procedures
E–8 058061 Tandem Computers Incorporated
Recovery Procedure B If you are using a Tandem 6511 or 6512 terminal and if the command
interpreter prompts you just after you press a function key, then follow
Steps 1 through 5. If you are using a Tandem 6520 or 6530 terminal, follow
Steps 3 and 4.
1. Press RESET once to unlock the keyboard.
2. Press MODE to put the terminal into conversational mode.
3. Type:
1 PAUSE
and EDIT VS should perform the operation for the key that you pressed
prior to the prompt. (After you type PAUSE, if the terminal displays:
FILE SYSTEM ERROR 11
or some other error message, you might have mistyped PAUSE. Try
again.)
4. When you return to EDIT VS, locate and remove the command
interpreter prompt character from your EDIT file.
5. If the keyboard is locked after you return to EDIT VS, press CONV MODE
to take the terminal out of conversational mode.
If this procedure does not work, the processor in which your EDIT VS
process is running might have failed. In this case, go to Procedure C,
below.