HP NonStop G-Series - Manual (Page 266)

EDIT Error Messages
EDIT Error Messages
A–8 058061 Tandem Computers Incorporated
THIS COMMAND ONLY WORKS INTERACTIVELY
EDIT must be running in an interactive mode (rather than noninteractively
or completing an OBEY command) to be able to start TEDIT. This means
that the IN and OUT parameters of the command that initially starts EDIT
must name the same device, which must be a terminal. By default, both
parameters name your terminal when you type EDIT at your command
interpreter.
If you get this message, ensure that EDIT is in an interactive mode, then try
the TEDIT command again. (See “Running the EDIT Program” in Section 4
for more information about the syntax of the EDIT command.)
THIS FILE CANNOT BE OPENED (FILE ERROR = errornum)
You were using the TEDIT command to start the TEDIT editing program
when EDIT had a problem opening the process that would start TEDIT.
This is an internal error that you cannot correct. Try the command again, or
tell your system operator.
THIS FILE IS FULL - 'PUT' IN ANOTHER FILE
The physical disk file is full. You must use the PUT command to put the
text into another file, possibly on another volume. See the PUT command in
Section 4 for help.
THIS FILE IS INVALID, SYNDROME n LOGICAL PAGE i j DO YOU WANT TO RECOVER?
When executing a GET command, EDIT found internal errors in the text
file. This is normal if a disk containing the file, the processor running EDIT,
or the EDIT process malfunctioned. Turn to the EDIT Error Recovery
Procedure in Appendix B for instructions on how recover.