HP NonStop G-Series - Manual (Page 155)

LIST Command
EDIT Command Summary
4–76 058061 Tandem Computers Incorporated
listfile
is $ device name , $ logical device number , or the name of a non-
EDIT-format disk file.
range-specifier
indicates combinations of line-range and string-range parameters. Turn
to “Range-Specifier Parameter” in Section 5 for a full explanation of this
range.
How to Use LIST If you omit the OUT parameter, listing occurs on the device specified in
the OUT filename parameter of the command to run the EDIT program.
If listfile is a line printer or a process, the file name of the current
file is printed at the top of each page; 56 text lines are listed per page.
If listfile is an unstructured disk file or a magnetic tape, text lines
are padded with blanks so that physical records are the length specified
by the OUTLEN parameter of the SET command; characters to the right
of the length specified in the OUTLEN parameter are listed on
subsequent line(s) and padded with blanks up to the length. (See
“Listing Text Onto Magnetic Tape” and “Listing Text Into a Non-EDIT-
Format Disk File,” following.)
If you omit a range parameter, EDIT lists the current line.
You can specify COL, UNSEQ or SEQ, and OUT in any order (but see
“Tip” at the end of the command description).