HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 87)

Virtual Connect networks 87
• Ethernet Settings (Advanced Settings) screen
o Set Server VLAN Tagging Support
o Set VLAN Capacity
o Use the Multiple Networks Link Speed Settings to set a custom value for preferred link connection
speed or maximum link connection speed
o Enable or disable MAC Cache Failover
o Modify the refresh interval for MAC Cache Failover
o Enable or disable network loop protection for all VC-Enet modules in the domain
o Reset network loop protection for all server ports in a loop-detected error state
o Enable or disable pause flood protection for all VC-Enet modules in the domain
o Reset pause flood protection for all server ports in a pause flood protected error state
o Configure LACP
• Quality of Service (QoS) screen (" Quality of Service screen " on page 102 )
o Prioritize network traffic to enhance performance
• IGMP Settings (IGMP Configuration) screen (" IGMP Snooping " on page 111 , on page 109 )
o Enable or disable IGMP Snooping
o Modify the idle timeout interval for IGMP Snooping
o Select to prevent flooding of unregistered multicast traffic
o Define multicast filters
o Edit multicast filters
o Delete multicast filters
• IGMP Settings (Multicast Filter Set) screen (on page 113 )
o Define multicast filter sets
o Edit multicast filter sets
o Delete multicast filter sets
• Define Ethernet Network screen (on page 114 )
o Define a new Ethernet network
• Edit Ethernet Network screen (on page 118 )
o Edit the properties of an existing network or delete a network
• Ethernet Networks (External Connections) screen (on page 121 )
o View a list of external connections for all Ethernet networks
o Edit a network
o Edit a shared uplink set
o Define a new network
o Delete a network
o Illuminate the PID for all uplink ports associated with a network
• Ethernet Networks (Server Connections) screen (on page 122 )
o Edit a network