HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 108)

Virtual Connect networks 108
Ingress Traffic Classifiers
The Classification for uplinks and Classification for downlinks pull-down lists allow you to choose what
classification method is applied to traffic in the specified direction. The default classification for uplinks is
DOT1P. The default classification for downlinks is DSCP/DOT1P. When both DOT1P and DSCP are being
used for one traffic flow, DSCP is used for IP traffic and DOT1P is used for non-IP traffic.
To change the classification, select an option for the pull-down list, and then click Apply.
Mapping
Each mapping entry has a key value and a traffic class to map matching packets to, as well as the egress
DOT1P priority value that a matching packet will be assigned. The pull-down lists all known traffic classes.
Only an enabled traffic class can be used in an active map.
To change the traffic class for an Ingress DOT1P Value or Ingress DSCP Value, select a traffic class from the
drop-down list, and then click Apply.
To reset the QoS configuration to default values, click Reset, and then click Apply. However, clicking Reset
and then clicking Apply resets the values on both the Ingress Traffic Classification tab and Traffic Class tabs
to the default values for active and inactive configurations.