HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 187)

Virtual Connect server profiles 187
All profiles created prior to the upgrade will remain unchanged and continue to operate similar to pre-4.01
behavior.
Example:
A configuration with HP VC Flex-10/10D modules in I/O Bays 1 and 2 and HP VC FlexFabric modules in
I/O Bays 3 and 4 in a pre-4.01 environment would only allow mapping of FCoE connections to the VC
FlexFabric modules in I/O Bays 3 and 4. A server profile in this environment would have the following
mapping for the Ethernet and FCoE connections.
Ethernet connections are shown in the following table.
Ethernet profile connection Map to bay Map to server port
1 1 LOM1:1A
2 2 LOM1:2A
3 3 Mezz1:1A
4 4 Mezz1:2A
5
1 LOM1:1B
6 2 LOM1:2B
7 3 Mezz1:1C
8 4 Mezz1:2C
9
1 LOM1:1C
10 2 LOM1:2C
11 3 Mezz1:1D
12 4 Mezz1:2D
13 1 LOM1:1D
14 2 LOM1:2D
FCoE connections are shown in the following table.
FCoE profile connection Map to bay Map to server port
1 3 Mezz1:1B
2 4 Mezz1:2B
Starting with VC v4.01, all newly created profiles map FCoE connections to I/O Bays 1 and 2 corresponding
to Flex-10/10D modules and allow for up to two additional FCoE connections to be mapped to I/O Bays 3
and 4. This reduces the number of viable Ethernet connections in the server profile.
Ethernet connections for new profiles have changed to the connections shown in the following table.
Ethernet profile connection Map to bay Map to server port
1 1 LOM1:1A
2 2 LOM1:2A (same)
3 3 Mezz1:1A (same)
4 4 Mezz1:2A (same)
5 1 LOM1:1C (same)
6 2 LOM1:2C
7 3 Mezz1:1C
8 4 Mezz1:2C
9 1 LOM1:1D
10
2 LOM1:2D