HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 42)

Virtual Connect domains 42
The VC-Enet SNMP settings apply to all VC-Enet modules in the Virtual Connect domain.
The following table describes the fields within the SNMP Configuration screen.
Field name Description
Enable SNMP Select to enable SNMP.
System Contact Specify a contact name for this system when SNMP is enabled.
Read Community Controls SNMP read access when SNMP is enabled. The default value for read
community string is "public". The read community string must always be set when
SNMP is enabled. The maximum length is 39 characters.
SNMP Access Table of networks that are allowed SNMP access
IP Address IPv4 address for the allowed network
Network Mask Bits Network mask bits for the allowed network
Type Type of network
Action Perform add and delete actions
SNMP Trap Destinations SNMP trap destination table
Destination
User-designated name for the trap destination. The Destination name must be
unique.
IP Address IPv4 address or DNS name for the trap destination
Community String The Community String acts like a password for a given trap destination. The
trap-receiving application can use the community string to filter the incoming traps.
Default: public
Action Perform edit and delete operations
The following table describes the available actions in the SNMP Configuration screen. Clicking another link
in the pull-down menu or left navigation tree causes current edits that have not been applied to be lost.
Task Action
Add SNMP access (" Adding
SNMP access " on page 44 )
Click Add below the SNMP Access table, or right-click on the header row
of the SNMP Access table, and then select Add.
Delete SNMP access Click Delete in the Action column, or right-click on the SNMP Access row,
and then select Delete.