Set up – Spectra Precision Survey Pro v3.80 Recon iPAQ User Manual User Manual

Page 85

Fieldwork

Set Up

Open the job that was created in the Traverse / Side Shot
Example.

From the Main Menu, select

)LOH , 2SHQ 1HZ to open the

Open / New screen.

Tap the file name that was created earlier
listed in the

Open Recent Job

list and then tap

2SHQ . The coordinates for that job are shown

here.

Set the job settings. (Only the settings that affect
this example are covered here.)

Select

-RE , 6HWWLQJV from the Main Menu.

Tap the

Instrument

tab and set both the

Brand

and

Model

fields to

Manual Mode

Tap the

Surveying

tab and confirm that all of

the checkboxes are unchecked.

Tap the

Stakeout

tab and make sure the final

field (

Cut Sheet Offset Stored)

is set to

Actual

Offset

Note: When performing stakeout, you have the option of storing cut
sheet information. This information is stored in the raw data file,
and when using software on a PC, such as Survey Link, it can be
extracted in the form of a Cut Sheet Report.

Tap OK to save the job settings.

Setup your backsight. In this example, we will setup on Point 1
and backsight an object where it is assumed that the direction to
that object is known. When connected to a total station, you
would setup over your occupy point, aim toward the backsight
and zero the horizontal angle in the total station before
continuing.

Access the

6XUYH\ , %DFNVLJKW 6HWXS screen.