Spectra Precision Survey Pro v3.80 Recon iPAQ User Manual - Manual (Page 128)

User’s Manual
120
are not sure if the units are in Feet or US Survey Feet into a job that
is set to Feet or US Survey Feet, you will usually just want to import
them without any conversion being performed. To do this, be sure to
select the same distance units for the source file as those set for the
current job.
Importing *.JOB Coordinates
The steps below will add the coordinates from any existing job (CR5
or JOB) to the current job.
1. With the job open that you want to add points to, select
)LOH ,
,PSRUW &RRUGLQDWHV .
2. In the Type field of the Import Coordinates screen, select Job Files
(*.job) .
3. Tap the desired JOB file that you want to import and then tap
OK.
4. Select the layer where you want to place the imported coordinates
from the Choose Layer screen.
Importing *.CR5 Coordinates
The steps below will add the coordinates from any existing job (CR5
or JOB) to the current job.
1. With the job open that you want to add points to, select
)LOH , ,PSRUW &RRUGLQDWHV from the Main Menu.
2. In the Type field of the Import Coordinates screen, select
Coordinate Files (*.cr5) .
3. Tap the desired CR5 file that you want to import and then tap
OK.
4. Select the layer where you want to place the imported coordinates
from the Choose Layer screen.