Spectra Precision Survey Pro v3.80 Recon iPAQ User Manual - Manual (Page 37)

Getting Started
29
station’s point of view. (This option only applies when a robotic total
station is selected in the Instrument Settings.)
; Display Left / Right From Rod (remote) : When checked, the move
left or right information will be presented from the rod person’s point
of view. When unchecked it will be presented from the total station’s
point of view. (This option only applies when a non-robot total station
is selected in the Instrument Settings.)
;
Prompt for Layer : when checked, a prompt to select a layer will
appear before any new point is stored from only the routines under
the Stakeout menu.
;
Prompt for Attributes : when checked, a prompt to select feature
information will appear before any new point is stored from only the
routines under the Stakeout menu. This also requires that a feature
file be selected from the Files Settings card, described earlier.
Note: There is no Prompt for Description checkbox as in the Survey
Settings because you will always be prompted for a description when
storing a point from a stakeout routine.
Horizontal Distance Tolerance : this setting affects the Remote
Staking and Stake to Line routines. When staking to a line and the
prism is located at a perpendicular distance to the specified line that
is within the range set here, a message will state that you are on the
line. When performing Remote Stakeout, the final graphic screen
that is displayed when you are near the stake point will occur when
you are within the distance to the stake point specified here.
Turn Gun To Design Point : only applies to motorized total stations.
The following options are available:
•
Yes: 2D (HA only) : The total station will automatically turn
horizontally toward the design point.
•
Yes: 3D (HA and ZA) : The total station will automatically turn
horizontally and vertically toward the design point.
•
No : The total station must be turned manually.
Cut Sheet Data stored : when storing a stake point, the data that is
stored depends on the following selection made here: