Spectra Precision Survey Pro v3.80 Recon iPAQ User Manual User Manual
Page 66
User’s Manual
58
7.
Tap the
,QVHUW button again and then tap the
Arc
tab to
insert a horizontal curve.
8.
Enter a
5DGLXV of
100
, a
'HOWD of
45
and select a
Right
turn. Check the
Make this segment tangent to
previous
checkbox so that the curve will be positioned
so the entrance to the curve is tangent to the end of the
previous segment.
9.
Tap OK to add the segment to the horizontal
alignment.
Note: A new segment can be inserted between two existing
segments by selecting the existing segment that is to occur
after the new segment and then tapping the
,QVHUW button.
10.
Tap the
,QVHUW button again and then tap the
Spiral
tab
to insert a spiral curve.
11.
Enter a
Radius
of
100
, a
Length
of
200
, select a
Right
of turn and a
CS to ST
direction, and check the
Make
this segment tangent to previous
checkbox.
12.
Tap OK to add the segment to the horizontal
alignment. This completes the horizontal definition.
You now need to define the vertical alignment.