Seed Hawk 30 SERIES: 600C & 800C 2013 - Manual (Page 70)

SEED HAWK® 30 SERIES OPERATOR’S MANUAL 70
4.22.7 REMOVE ALL SENSORS
This menu item is used when installing a previously used monitor on a new system. Selecting
this item will clear the monitor’s memory of all learned sensors. This selection cannot be
undone. This selection does not affect CAN based sensors (meters and down pressure), only
MUX based sensors (ground speed, fan speed, bin level).
4.23 ALARMS
The alarm display will become active when any conditions fall below or rise above the set alarm
point. For example: Low Bin level, No Ground Speed, Low or High Fan Speed and Low Meter
Speed are all alarm conditions. All alarms operate in a similar fashion: An audible alarm will
sound and an alarm message will appear on the display instructing the user to press the soft
key labeled F1 to acknowledge the alarm.
Once acknowledged, the audible alarm will cease and an icon of a bell at the top of the display
will flash. Also, an icon associated with the specific alarm will blink. For example if the bin level
alarm for bin #1 becomes active and is acknowledged, the Bin 1 icon will flash along with the
alarm bell icon. If bin 2 then shows an alarm condition then the audible alarm will sound again.
Once acknowledged, the bin 1 and bin 2 icons will flash along with the alarm bell icon.
Low and High fan speed alarms can’t be acknowledged. The alarm condition must be corrected
to clear the screen of the alarm warning and to quiet the audible alarm. If this alarm is going off
in error, check the high and low alarm point settings by going to the sensor configuration
menu, highlighting the sensor in question and pressing the “Settings” soft key.
FIGURE 4.79