Seed Hawk 30 SERIES: 600C & 800C 2013 - Manual (Page 59)

SEED HAWK® 30 SERIES OPERATOR’S MANUAL 59
6. Ignore/Revive: The user can temporarily
disable sensors by placing the highlight bar on
the desired sensor selecting Ignore. Re‐enable
that sensor by placing the highlight bar on the
sensor and selecting Revive. This is used to
disable a sensor if a part of the system is not
being used such as a bin that is left empty. By
ignoring the sensor you will eliminate unwanted
alarms.
4.19 GLOBAL SETTINGS
Use this menu selection to set the units of
measure, language, implement width, the
volume of the alarm, the backlight and contrast
of the screen, and the master switch mode. To
access the Global Settings from the run screen
press any soft key to bring up the soft key menu
and press “Setup”. Navigate the highlight bar to
the “Global Settings” selection and press
“Enter”.
At this screen the user can review the basic system setup and make changes as necessary. To
make changes, navigate the highlight box to the item wishing to adjust and press “Enter”. A
drop down box will appear and show the choices. Navigate to the choice wanted and press
enter.
1. Units: Available choices are Metric, Imperial,
and US Imperial. Navigate to the selection you
want and press “Enter”.
FIGURE 4.52
FIGURE 4.51
FIGURE 4.50