Seed Hawk 30 SERIES: 600C & 800C 2013 User Manual
Page 61
SEED HAWK® 30 SERIES OPERATOR’S MANUAL
61
5. Backlight: Sets the display backlight level. Navigate
to this selection and press the spinner knob to
highlight the item. Rotate the spinner knob to
increase or decrease the backlight and press the
spinner knob or “Enter” to set the new backlight
setting.
6. Contrast: Sets the display contrast. Navigate to
this selection and press the spinner knob to highlight
the item. Rotate the spinner knob to increase or
decrease the contrast and press the spinner knob or
“Enter” to set the new contrast setting.
7. Master switch mode: The choices are “Manual”
and “Auto”. Manual is used when the operator
engages and disengages the drive by pressing the
“ACK” button at the beginning and end of each pass.
Auto is used when a lift switch on the implement
engages and disengages the drive. Manual is the
normal mode of operation.
8. OK/Cancel: Select “OK” to save any changes that
have been made or Cancel to ignore changes that
have been made.
FIGURE 4.56
FIGURE 4.59
FIGURE 4.57
FIGURE 4.58