Appendix, 1 setup of connection with omron’s master unit, 2 automatic network setup – IAI America PCON-CFA User Manual
Page 263
6. Appendix
257
6. Appendix
6.1 Setup of Connection with Omron’s Master Unit
The following devices and software are required to connect to an Omron master.
[1] PLC CPU unit:
(Ex) CJ1G-CPU43H
[2] EtherCAT(R) master unit (Position control unit):
(Ex) NC-882
[3] Setting software:
CX-One V4.0 or later CX-Programmer V9.11 or later
[4] IAI controller designed for EtherCAT(R)
6.2 Automatic Network Setup
The setup procedure is as follows:
[1]
Open CX-Programmer. Double-click I/O Table/Unit setting listed on the project tree, and open the I/O
table.
[2] Double-click the field for CJ1W-NC882 position control unit (EtherCAT(R) communication type) on the
CPU rack tree and launch the position control unit setting tool (hereinafter referred to as the "NCF
tool").