IAI America RCP2W-RA10C - Manual (Page 50)

44
5. Installation
(4) Using tapped holes on datum surface
[A] Applicable models: RA2C, RA3C, RA4C, RA6C, RA3R, RA4R, RA6R, RA10C types
(Not applicable to guide types)
The thread depths of mounting holes provided in the respective actuators are shown below.
Model Tapped hole size Effective thread depth
m m 6 3 M C 2 A R
RA3C, RA3R M4 10 mm
RA4C, RA4R M6 12 mm
RA6C, RA6R M8 15 mm
(RCP2W-RA4C) M8 12 mm
RA8C, RA8R M8 16 mm
Tapped mounting holes are provided
on the datum surface. Install the
actuator using these tapped holes.
RA10C M10 18 mm