IAI America RCP2W-RA10C - Manual (Page 23)

17
x Connect a tube to the intake/exhaust port and extend the other end of the tube to a location not
subject to water, etc.
Internal structure of intake/exhaust port
Part
No.
Name Material
[1] Intake/exhaust port PBT
[2] Gasket NBR
[3] Holder C3604BD
[4] Chuck SUS301
[5] Outer ring C3604BD
[6] Push ring Polyacetal
[7] O-ring NBR
[8] Driven nipple C3604BD
Model
Outer diameter x
inner diameter mm
Material
U-9506 6 X 4 Polyurethane
Grease supply port
(Truss head screw)
The joint can be turned 360 degrees.
Intake/exhaust port
[2] [3] [6] [5]
[1]
[7]
[8] [4]
Tube
x Insert the tube all the way until it contacts the
gasket [2] shown to the left. If the tube is not
inserted fully and the tip of the tube stops at
the chuck [4], water or other foreign matter
will enter the interior, causing the actuator to
malfunction.
Intake/exhaust port
Joint CL-061 by Aoi
Applicable tube (Aoi)
RA4C type
RA6C type
Right
Front
Left
Motor side
Aluminum frame
Motor bracket
Motor end cap
Cable
Motor cover
Range of T-groove
Rod
Rod tip adapter