IAI America RCP2W-RA10C - Manual (Page 24)

18
Connect a tube to the intake/exhaust port and extend the other end of the tube to a location not
subject to water, etc.
(Note) There is no grease supply port on those manufactured in the early time.
Internal structure of intake/exhaust port
Part
No.
Name Material
[1] Intake/exhaust port PBT
[2] Gasket NBR
[3] Holder C3604BD
[4] Chuck SUS301
[5] Outer ring C3604BD
[6] Push ring Polyacetal
[7] O-ring NBR
[8] Driven nipple C3604BD
Model
Outer diameter x
inner diameter mm
Material
U-9506 6 X 4 Polyurethane
[2] [3] [6] [5]
[1]
[7]
[8] [4]
Tube
RA10C type
The joint can be turned 360 degrees.
Right
Front
Left
Motor side
Rod tip fitting
Rod
Cable
Wire cover
Intake/exhaust port Tie rod
Base
Motor cover
Rear cover
Motor bracket Front bracket
Insert the tube all the way until it contacts the
gasket [2] shown to the left. If the tube is not
inserted fully and the tip of the tube stops at
the chuck [4], water or other foreign matter
will enter the interior, causing the actuator to
malfunction.
Intake/exhaust port
Joint CL-061 by Aoi
Applicable tube (Aoi)
Grease supply port
(thin head screw)