IAI America RCP2W-RA10C - Manual (Page 44)

38
4. Installation Environment, Storage and Preservation Environment
6. Operating and Storage Environment
6.1 Operating Environment
The actuator should be set up in an environment, which meets the following criteria:
x Avoid direct sunlight.
x Avoid radiant heat from strong heat sources such as a furnace.
x Surrounding air temperature should be 0 ~ 40qC.
x The humidity should be less than 85% and there should be no condensation.
x Avoid exposure to corrosive or combustible gases.
x The area should have very little dust and be suitable for normal assembly operations.
x Avoid exposure to oil mist or fluids used in cutting.
x The unit should not be subject to impact or vibration.
x Avoid extreme electromagnetic waves, ultraviolet rays and radiation.
x This product is not intended to be used in a chemical environment.
In general, the environment should be one in which an operator can work without protective gear.
* If you are considering the dustproof/splashproof type (RCP2W), consult IAI for the applicable
installation environment.
6.2 Storage Environment
The storage environment should be similar to the operating environment. In addition, you must take
precautions against condensation if the unit is to be stored for a long period of time. Unless there are
special instructions, we do not include moisture absorption agents when shipping the unit. If you are
storing the unit where condensation might occur, then you must treat the entire package or treat the unit
itself after it is unpacked to prevent condensation. The unit can withstand up to 60
qC during a short
storage interval but only up to 50 qC if the storage period is longer than one month.
4. Installation Environment, Storage and Preservation Environment
The storage and preservation environment should comply with the same standards as those for the
installation environment. In particular, when the machine is to be stored and preserved for a long time, pay
close attention to environmental conditions so that no dew condensation forms.
Unless specially specified, moisture absorbency protection is not included in the package when the
machine is delivered. In the case that the machine is to be stored and preserved in an environment where
dew condensation is anticipated, take the condensation preventive measures from outside of the entire
package, or directly after opening the package.
For storage and preservation temperature, the machine withstands temperatures up to 60
qC for a short
time, but in the case of the storage and preservation period of 1 month or more, control the temperature to
50
qC or less.
4.1 Installation Environment
4.2 Storage and Preservation Environment